Saturday, August 02, 2008

Make your own Dog Agility Jump

Been putting off this one for a while, so I decided i'd finally make it. My very own homemade dog agility jump for Montana. It was way easy than I thought. I figured i'd make it out of PVC pipe and some couplers.

I bought two 10' 3/4" PVC pipes and bag of tee joints for 3/4" PVC pipe. I cut the PVC pipe into:
With those pieces cut, I put together the 12" sections in 2 upside down Ts. I put another tee joint on top of the 12" piece that would be facing up, and then a 6" section and another tee joint and then one more 6" section.

In the end, I have a dog agility jump that can set at 12", 18", and 24". Or, I suppose I could mix it up and have it settable at 6", 12" and 24". And can easily modified to any height with a little more PVC pipe cutting. And all for $6!




Comments:
You. Are. A. Nerd!
 
Post a Comment





<< Home

This page is powered by Blogger. Isn't yours?

Subscribe to Posts [Atom]